2018

Fastener kit comes with the following hardware:Supplied per arm: 2   - 7 gram tungsten inserts  16 - 1 gram washers 4 -  M5x12mm screws    4  - M5x10mm screws   4  - M5x8mm screws 4  - M5x6mm screws 2...

A non fixed bushing style arm incorporating our signature style of adjustability to offer the most tuning capabilities available. Each arm needs our 1001709 bushings for the 8mm Non fixed .470 wide pin style rage primary 

Replacement part for Pneumatic for X# Turbo "D" lock 35MM BC Crank   M14-1.5 x 4.09"

  NON-FIXED PIN Fastener kit comes with the following hardware:   This kit is for cam arms that utilize bushings to pivot on the pin kit.   This fastener kit comes with the following hardware: PER ARM         ...

New Style tied bearing brace 12.5" center to center lower bracket

New Style tied bearing brace 12.5" center to center upper bracket

Replacement cover for Rage 4 WSP Pneumatic Primary.  Allows the use of part # 1001580 Pneumatic Clutch Cover Holding Tool.

Rage 3 wide replacement movable sheave, comes with bushing and snap ring  Fits   X3 / Defender and Maverick Trail               3-6-20MH

New Style tied bearing brace 11.5" center to center upper bracket

This cover is designed for and works only with the STM Can-Am Rage 3S Primary.

Convert the STM rage 3WCP primary clutches part numbers 3001121 to run high engagement  Qty 1 #7001005 Bolt with M14 Lock washer Qty 1 #1001171 Adjuster Nut Qty 1 #1001172 .060 Nylon Shim Qty 1 #1001173 .030 Nylon Shim Qty 1 #1001630...

ONLY WORKS IN STM CLUTCHES  Sold each set. 1 pin and bushing set per arm is needed. Only for .470 wide cam arms with 8mm AXI 1001709 bushings.   Includes:  2 -  1001324 Inner bushings for 1/4" pins  2 -...