ATV/UTV, Side By Side

STM Tuner Bolt Retaining Washer  Fits  2014-15 Polaris XP1000 and Jagged X STM APEX/Z-1 Conversion Tuner Secondary's      MH3-4-20

Works with all 3020 style bushings  ATV Helix Cap bushing press tool, one side is used to press the bushings in with ease while flipping the tool over it is also used to press the bushing out if needed. A very handy tool that makes pressing bushings...

Sold individually. These are the bushings that go from the inside of the clutch where the cam arm pin goes through for 5/16" pins with .570 wide weights (.048 shoulder). These are made from billet aluminum   

Bolt M14-1.5x8.25 and lock washer.

This tool fits all pneumatic clutch styles. Press pieces married in holes for your application only. Used to hold the clutch for torquing the main bolts and actuator parts.  

STM Rage 3 Wide Primary Replacement cover, comes with bushing #1810.590 and retaining clip.

ATV Primary Fixed Sheave comes with fixed sheave part# 2001107 and post part# 2001084 assembled 

Our billet cover is a rigid design made from 6061 aircraft aluminum. This design captures the towers of the movable sheave and helps stop them from spreading.  Our billet cover also allows the use of the Ski-Doo TRA springs which offers a...

6 arm snowmobile screw-on spider.  Comes complete with rollers, buttons and 1st stage arms. 

Replacement primary M14 retaining washer and steel wedge lock washer (91074A134) with primary post bore of .750

Replacement bearing cap for Rage 3W clutch.

New improved two-way bearing design. The main shaft bearing is now smaller with a 47mm outside diameter allowing a lower initial takeoff ratio than our past design. Allows tighter belt deflection and smoother transmission shifting. An affordable...