►Cam Arms

Made specifically for higher engagement aggressive drag racing applications with an all new flatter profile specifically for turbo models. Made with a healthy engagement notch. The notched arms were...

Rage 6 & 8 1st stage arm pin set. Includes: 1 - arm pin 2 - steel washers 2 - 8-32 x 1/2" screws

  These SUPERTIP Cam Arms are not recommended at RPM ranges above 9000 RPM  Our fastener kit comes with the following hardware; Qty supplied per arm  2  -  Tungsten Inserts - 7 grams  16 -...

We now have an XP 800R clutch kit that comes with a TRA spring and the arms set up to the proper weight. This set up works awesome with the stock secondary as  shown in our Dyno graph and has been...

Supertip X Series Notched Drag Race Cam Arms

These cam arms were specifically designed for the Z1 Turbo upgrade. This a new proven and tested design that is prefered by Z1 tuners. These arms have a large hump on the back that creates more...

Made specifically for higher engagement aggressive drag racing applications. Made with a healthy engagement notch. The notched arms were designed for the Rage primary and will also fit Arctic Cat...

New improved profile that provides a harder up shift than the Original Supertips. We are very pleased with testing results on the race track and chassis Dyno this past season.  We found faster ETs...

Available in 50, 60 and 72 gram increments with the capability of adding 32 grams per arm for adjustment. This design allows the option of adding large quantity of weight to three different areas on...

Available in 50 and 60 gram base with the capability of adding 32 grams per arm for adjustment. This design allows the option of adding large quantity of weight to three different areas on both...

Set of 6 bushings only  **Updated part# from 37 BU Replacement bushings for the STM Supertip weights. This bushing will be required when running the 1/4" pins.  Use on 40, 50, and 60 gram weights...

Set of 2 bushings only **Updated part# from 37 BU Replacement bushings for the STM Supertip weights. This bushing will be required when running the 1/4" pins.  Use on 40, 50, and 60 gram weights...