Commander

A heavy duty tool (also known as the grunt tool) that allows you to remove and install your spider. It will work on the primary clutch cover as well to hold it from turning while torquing the clutch bolt. This tool works on all STM Rage 4 & 8...

The Newest addition to our Rage3 line of primary clutches This Rage 3RA is an STM primary designed with "Short Post" offset allowing it to ONLY be used with the STM Short Post Seconday clutches . To take full advantage of an optimal...

New improved two-way bearing design. The main shaft bearing is now smaller with a 47mm outside diameter allowing a lower initial takeoff ratio than our past design. Allows tighter belt deflection and smoother transmission shifting. Click here to order...

New improved two-way bearing design. The main shaft bearing is now smaller with a 47mm outside diameter allowing a lower initial takeoff ratio than our past design. Allows tighter belt deflection and smoother transmission shifting. An affordable...

The Rage 3P is an STM primary designed with the stock offset allowing it to be used with the stock secondary. To take full advantage of an optimal setup we suggest using the STM Tuner driven Can-Am long post along with the Rage 3P...

  The Rage 3P is an STM primary designed with the STM short post that works only with the STM short post secondary.  STM Tuner driven Can-Am short post . This Rage Primary will not work with the stock Secondary clutch  This...

STM Tuner Secondary Base Tool will sit on your bench and works great for removing and installing the helix and spring along with changing belt deflection.

Belt removal tool for the STM ATV tuner for Can-Am.  1/2"-13 thread Will not work with Maverick X3, Defender, Maverick Trial or Maverick Sport.   

This compression tool will allow you to change weights in your clutch without removing it from the crank. Simply remove the belt and clutch bolt, screw in the m14 x 1.5 thread rod with the plastic cup and tighten the nut to collapse the sheaves.

Pocket gram scale. Maximum 200 gram capacity. Perfect tool for setting up your cam arms. Comes with batteries, protective cover, storage case  and is calibrated. Gram scale is 4.6 x 2.5 x 0.7 inch and weight under 4 ounces Weight platform...

Works with all 3020 style bushings  ATV Helix Cap bushing press tool, one side is used to press the bushings in with ease while flipping the tool over it is also used to press the bushing out if needed. A very handy tool that makes pressing bushings...

Works with all 1810 style bushings  All STM primary cover Primary cover bushing press tool, one side is used to press the bushings in with ease while flipping the tool over it is also used to press the bushing out if needed. A very handy tool that...