Maverick 1000 / Max / XDS Turbo / XDS Turbo Max

Fastener kit comes with the following hardware:Supplied per arm: 2   - 7 gram tungsten inserts  16 - 1 gram washers 4 -  M5x12mm screws    4  - M5x10mm screws   4  - M5x8mm screws 4  - M5x6mm screws 2...

Can-Am Tuner Secondary STM Gen 1 Fixed sheave assembly includes sheave and post for the stock or STM Rage 3S primary offset tuners only. THIS IS STM GEN1 Models. Fits Gen1 and Gen2 Machines. Make sure you verify your clutch before ordering...

Replacement sheave for the Can-Am STM Tuner Secondary Gen 1. Includes bushing and bushing retaining clip installed.

STM Primary Rage 3WSP-ER (Endurance Race) Fixed Sheave and Post assy. Comes with fixed sheave part# 1001336  and post part# 3001146 assembled.  This is a non bearing design fixed sheave for the ER (Endurance Race) primary applications...

PS type springs

2 1/2" load 1 1/4" load

for use in STM Primaries

Pin roller kit for STM HD Rage 4 and 8 arm spider.  This kit includes: 4- 1001634 - .610 Rollers 8- 1001544 Bushings 4- M10 x 28mm Dowel Pin 8- 1001146 .218 Rebuild buttons Works with STM HD Rage 4 & 8 spiders.

Clutch holding tool for STM primary clutches. This tool designed to be put into a vice to be able to hold STM primary clutches for assembly and disassembly. 

CanAm STM Tuner Secondary bolt for secondary assembly part numbers Fits gen one and 2 tuners Not 3001065 (X3, Defender, Maverick Trial or sports!)  M10-1.5x105mm SHCS (Socket Head Cap Screw) 

STM clutch support brace designed to tie the pneumatic primary and secondary together to prevent shaft flexing for improved performance and belt life.  WORKS WITH STM PRIMARY AND SECONDARY ONLY     

ONLY WORKS IN STM CLUTCHES  Sold in a per arm set. 1 pin and bushing set per arm is needed. Includes: 2 -  1001317 inner bushings for .570 wide weights .048 shoulder bushing 2 -  1001316 outer bushings for .125...