Maverick X3 /Max Turbo/ Sport / Trail / Turbo

ONLY WORKS IN STM CLUTCHES  **Updated part # from 26RYCA** Sold each set. 1 pin and bushing set per arm is needed. Works with fixed style cam arms that have set screws to fix the arm to the pins. Only for .570 wide cam arms with 8mm bushings...

30-12 bushing cut down and snap ring Fits All STM Primary Movables Sheaves for 1.875" post 35mm HD movable sheave snowmobile. Can Am DR  Can Am HD-DR All Pneumatic movable sheaves   

2 1/2" load 1 1/4" load

Used for removing the spider nut from the screw-on all STM clutches and 1995 thru 2009 and 2016 team Arctic Cat primary clutches.  Fits ALL Screw-on style STM clutches regardless of year. Replaces 1001072 STM & Arctic Cat Spider Nut Socket...

Bushing and retaining clip.

Replacement Primary M14-1.5x 8.5" Retaining Bolt Replacement for 2001165  *85 Ft Lbs Torque *when using retaining washer / lock washer sku: 2001328 the torque spec is 55 ft lbs following the steps on the instructions provided with...

1816 bushing includes VH131 retaining clip

2610 bushing and VH181 Snap Ring 

This retaining washer is to fit the .750 post end STM primary clutch on the XDS Turbo. Use stock primary bolt with this retaining washer and lock washer included. 

A heavy duty tool (also known as the grunt tool) that allows you to remove and install your spider. It will work on the primary clutch cover as well to hold it from turning while torquing the clutch bolt. This tool works on all STM Rage 4 & 8...

Nylon spacer goes between the spring and helix cap to prevent wear. Use with KSS style springs and HD compression spring helix cover #1001067 and Cf-Moto secondary clutches 

This compression tool will allow you to change weights in your clutch without removing it from the crank. Simply remove the belt and clutch bolt, screw in the m14 x 1.5 thread rod with the plastic cup and tighten the nut to collapse the sheaves.