Commander
-
STM Gen 2 Tuner Secondary Can-Am (fits OG Maverick, Commanders, Gen 1 and Gen 2 Outlanders/Renegades)
$700.00PLEASE WATCH THE VIDEO BELOW IF YOU NEED HELP CHOOSING YOUR OPTIONS! 2014 Maverick's will require an upgraded clutch housing flange adaptor for the inlet tube to allow installation of the STM...$700.00 -
STM Rage 4 & 8 Spanner Tool
$92.00A heavy duty tool (also known as the grunt tool) that allows you to remove and install your spider. It will work on the primary clutch cover as well to hold it from turning while torquing the clutch...$92.00 -
STM Rage 3-RA Short Post Primary Can-Am Works with STM Short Post Secondary Clutches Only
STM
$1,502.00The Newest addition to our Rage3 line of primary clutches This Rage 3RA is an STM primary designed with "Short Post" offset allowing it to ONLY be used with the STM Short Post Seconday clutches .$1,502.00 -
STM Rage 6RS Can-Am Primary
$2,014.00New improved two-way bearing design. The main shaft bearing is now smaller with a 47mm outside diameter allowing a lower initial takeoff ratio than our past design. Allows tighter belt deflection and...$2,014.00 -
STM Rage 8 Primary Can-Am
$2,342.00New improved two-way bearing design. The main shaft bearing is now smaller with a 47mm outside diameter allowing a lower initial takeoff ratio than our past design. Allows tighter belt deflection and...$2,342.00 -
STM Rage 3P (Low End Torque and Engagement) Primary Can-Am Works with Stock or STM Long Post Secondary
STM
$1,393.00The Rage 3P is an STM primary designed with the stock offset allowing it to be used with the stock secondary. To take full advantage of an optimal setup we suggest using the$1,393.00 -
$1,393.00 -
Currently Out of Stock, Please check back again
STM Tuner Secondary Base Tool
$92.00STM Tuner Secondary Base Tool will sit on your bench and works great for removing and installing the helix and spring along with changing belt deflection.$92.00 -
STM ATV Tuner Belt Removal Tool - Can-Am 1/2"-13 (not for X3. Trail, Sport or Defender)
$36.00Belt removal tool for the STM ATV tuner for Can-Am. 1/2"-13 thread Will not work with Maverick X3, Defender, Maverick Trial or Maverick Sport.$36.00 -
Can-Am & Segway STM Rage ATV Primary Compression Tool M14x1.5
$36.00This compression tool will allow you to change weights in your clutch without removing it from the crank. Simply remove the belt and clutch bolt, screw in the m14 x 1.5 thread rod with the plastic...$36.00 -
Currently Out of Stock, Please check back again
Gram Scale.
$25.00Pocket gram scale. Maximum 200 gram capacity. Perfect tool for setting up your cam arms. Comes with batteries, protective cover, storage case and is calibrated. Gram scale is 4.6 x 2.5 x 0.7 inch...$25.00 -
ATV Helix Cap 3020 Bushing Press Tool
$44.00Works with all 3020 style bushings ATV Helix Cap bushing press tool, one side is used to press the bushings in with ease while flipping the tool over it is also used to press the bushing out if...$44.00