Rage 3 Components

2610 bushing and VH181 Snap Ring 

This compression tool will allow you to change weights in your clutch without removing it from the crank. Simply remove the belt and clutch bolt, screw in the m14 x 1.5 thread rod with the plastic cup and tighten the nut to collapse the sheaves.

TRA spring spacer for the STM Rage primary clutch. These spacers go in each end of the TRA spring to protect the cover and spider from spring damage.

30mm screw-on belt shim .03 thick.  Sold individually.

Spider retaining nut STM Rage Primary Clutches 

Screw-on spider shim .06 thick. Fits 30 and 35mm taper.

Bushing Retaining Clip.

Belt washer for all STM primary clutches with a 1.875" diameter Post  Fits  All STM Pneumatic Primary's  All STM 35mm HD Primary's   Can Am X3 HDDR Primary's 30mm WSP 4 Stroke Primary's 33mm WSP 2 Stoke...

Screw-on spider shim .03 thick. Fits 30 and 35mm taper.

Shim for Rage primary quick adjust - needs 2. Sold individually.

STM Primary Clutch Puller  Fits  STM Rage 4 HD-DR Can Am X3 primary **DOES NOT WORK ON STOCK X3 PRIMARY CLUTCH OR STM WCP PRIMARY CLUTCH** For stock clutch or STM WCP clutch click here        MH

Snowmobile Primary Fixed Sheave and Post assembled