Rage 4 Components

A heavy duty tool (also known as the grunt tool) that allows you to remove and install your spider. It will work on the primary clutch cover as well to hold it from turning while torquing the clutch bolt. This tool works on all STM Rage 4 & 8...

This compression tool will allow you to change weights in your clutch without removing it from the crank. Simply remove the belt and clutch bolt, screw in the m14 x 1.5 thread rod with the plastic cup and tighten the nut to collapse the sheaves.

Spider retaining nut STM Rage Primary Clutches 

30mm screw-on belt shim .03 thick.  Sold individually.

Spider - pin & roller rebuilt kit for Rage 4 WIDE spider only! Includes: 4 - 1001634  .610 Rollers 8 - 1001544 Bushings 4 - M10 x 36mm Dowel Pins 8 - 1001146 .218 Rebuild Buttons Replaces 1001591  

Bushing Retaining Clip.

Pin roller kit for 4 and 8 arm spider.  NOT FOR USE IN 3VL PRIMARY CLUTCHES! for 3vl pin roller kits please Click Here  This kit includes new buttons, rollers with composite style bushings, pins and washers. Works with all STM Rage 4 & 8...

This compression tool will allow you to change weights in your STM primary clutch without removing it from the crank. Simply remove the belt and clutch bolt, screw in the thread rod with the plastic cup and tighten the nut to collapse the sheaves...

Screw-on spider shim .06 thick. Fits 30 and 35mm taper.

Screw-on spider shim .03 thick. Fits 30 and 35mm taper.

Cover screw set for the STM snowmobile and some ATV/UTV Rage 4 and 8 primary clutches.   1/4-20 x1 HHFS set of 8 for counter bore cover. Torque to 125 in/lbs.

STM Primary Clutch Puller  Fits  STM Rage 4 HD-DR Can Am X3 primary **DOES NOT WORK ON STOCK X3 PRIMARY CLUTCH OR STM WCP PRIMARY CLUTCH** For stock clutch or STM WCP clutch click here        MH