STM Rage 3 Replacement Componenets

Pin roller kit for 3 arm WIDE spider.    This kit includes: 6-1001146  .218 Rebuild Buttons 3- 1001634  .610 Rollers 6- 1001544 Roller Bushings 3- M10x36mm Dowel Pins   Replaces 1001573

A heavy duty tool (also known as the grunt tool) that allows you to remove and install your spider. It will work on the primary clutch cover as well to hold it from turning while torqueing the clutch bolt. This tool works on all STM Rage 3 & 6...

Bushing and retaining clip.

TRA spring spacer for the STM Rage primary clutch. These spacers go in each end of the TRA spring to protect the cover and spider from spring damage.

STM Primary Clutch Puller  Fits  STM Rage 4 HD-DR Can Am X3 primary **DOES NOT WORK ON STOCK X3 PRIMARY CLUTCH OR STM WCP PRIMARY CLUTCH** For stock clutch or STM WCP clutch click here        MH

Belt washer for all STM primary clutches with a 1.875" diameter Post  Fits  All STM Pneumatic Primary's  All STM 35mm HD Primary's   Can Am X3 HDDR Primary's 30mm WSP 4 Stroke Primary's 33mm WSP 2 Stoke...

.030" thick belt shim for stm primary clutches with a 1.875" dia post. Sold individually            MH 3-3-20

This compression tool will allow you to change weights in your clutch without removing it from the crank. Simply remove the belt and clutch bolt, screw in the thread rod with the plastic cup and tighten the nut to collapse the sheaves.  5/8-18...

.075" thick spider shim  Fits  All STM ATV primary's with a Sleeved 2 way Bearing  All STM Primary's with a 1.875" diameter post    MH 3-3-20

ONLY WORKS IN STM CLUTCHES  Sold in a per arm set. 1 pin and bushing set per arm is needed. Includes: 2 -  1001317 inner bushings for .570 wide weights .048 shoulder bushing 2 -  1001316 outer bushings for .125...

ONLY WORKS IN STM CLUTCHES  Sold in a per arm set. 1 pin and bushing set per arm is needed. Includes: 2 -  1001317 inner bushings for .570 wide weights .048 shoulder bushing 2 -  1001316 outer bushings for .125...