STM Rage Primary Replacement Components

ONLY WORKS IN STM CLUTCHES  **Updated part # from 27ACS312** Sold in a per arm set. 1 pin and bushing set per arm is needed. Works with non-fixed style cam arms only for .570 wide cam arms.  Non-Fixed Pin only works with cam arms that have...

30-12 bushing cut down and snap ring Fits All STM Primary Movables Sheaves for 1.875" post 35mm HD movable sheave snowmobile. Can Am DR  Can Am HD-DR All Pneumatic movable sheaves   

Bushing and retaining clip.

2610 bushing and VH181 Snap Ring 

1816 bushing includes VH131 retaining clip

A heavy duty tool (also known as the grunt tool) that allows you to remove and install your spider. It will work on the primary clutch cover as well to hold it from turning while torquing the clutch bolt. This tool works on all STM Rage 4 & 8...

Replacements for spiders that came with these HD arms. Arms are sold individually and come with bushing already installed. HD 1st stage M5 fastener kit required with these arms and is sold separately.  These Cam Arms are not recommended at...

This compression tool will allow you to change weights in your clutch without removing it from the crank. Simply remove the belt and clutch bolt, screw in the m14 x 1.5 thread rod with the plastic cup and tighten the nut to collapse the sheaves.

TRA spring spacer for the STM Rage primary clutch. These spacers go in each end of the TRA spring to protect the cover and spider from spring damage.

Spider retaining nut STM Rage Primary Clutches 

Spider - pin & roller rebuilt kit for Rage 4 WIDE spider only! Includes: 4 - 1001634  .610 Rollers 8 - 1001544 Bushings 4 - M10 x 36mm Dowel Pins 8 - 1001146 .218 Rebuild Buttons Replaces 1001591  

30mm screw-on belt shim .03 thick.  Sold individually.