2009

A heavy duty tool (also known as the grunt tool) that allows you to remove and install your spider. It will work on the primary clutch cover as well to hold it from turning while torqueing the clutch bolt. This tool works on all STM Rage 3 & 6...

Replacement bushings for the STM Supertip R-series weights and the P-series weights. These bushings get pressed in and reamed after installation. Reamers available as part # RMR in sizes .251, .248, .311, & .317. Purchase separately.

First stage cam arm bushing. Updated part number from 0404. Updated from original composite material to aluminum. 

Primary clutch .125 spring shim spacer 

ONLY WORKS IN STM CLUTCHES  Includes: 1 -  5/16 x 2 1/4" shoulder bolt with set screw dimple 1 -  1/4 - 20 Nyloc nut  

This is a Gen 2 style bearing 47mm non sleeved. Only works with sheaves that have previously had 47mm bearing.

STM Can-Am tuner movable sheave bushing.

Replacement bushing for PN 1001304 Cover  

ONLY WORKS IN STM CLUTCHES  **Updated part # from 27ACS312** Sold in a per arm set. 1 pin and bushing set per arm is needed. Works with fixed style cam arms that have set screws to fix the arm to the pins-only for .570 wide cam arms...

Fastner kit comes with the following hardware:Supplied per arm: 2   - 7 gram tungsten inserts  16 - 1 gram washers  4   - O-rings  8  - M3 x 6 long screws  2  - set screws  Supplied per kit...

Rage 6 & 8 1st stage arm pin set. Includes: 1 - arm pin 2 - steel washers 2 - 8-32 x 1/2" screws

ONLY WORKS IN STM CLUTCHES  **Updated part # from 28ACS312** Sold in a per arm set. 1 pin and bushing set per arm is needed. Works with non-fixed style cam arms Non-Fixed Pin only works with cam arms that have a bushing.  Updated from...