2014 and eariler models

  This Rage 3RS is an STM primary designed with the STM Short Post offset NOT allowing it to be used with the stock secondary.   This clutch offers extremely smooth low engagement with improved torque. New improved two-way bearing design...

Made from billet aluminum. Comes assembled with rollers and buttons. 

2-Way Bearing Cap for Can-Am X3 4YS Part# 3001082

ATV Movable Sheave Gen 2 comes with bushing and bushing retainer installed.

This is a replacement movable sheave for the single stage Rage 3 CanAm x3 STM primary's  Includes: 1 - Movable sheave 1-  Bushing installed 1 - Bushing retaining clip installed 

Can-Am Tuner Secondary STM Gen 1 Fixed sheave assembly includes sheave and post for the stock or STM Rage 3S primary offset tuners only. THIS IS STM GEN1 Models. Fits Gen1 and Gen2 Machines. Make sure you verify your clutch before ordering...

For use with adjuster nut Sku: 1001717

STM Rage 4 Wide Primary Replacement cover, comes with bushing #1810.590 and retaining clip.

Turner adjustment nut with 1/4"-20 tapped holes to use a bolt to open the secondary while leaving the adjust nut in place. Must be used with adjuster nut washer Sku: 1001716

This will only work on Can-Am X3 primary assembly part numbers  3001101 Rage 4 DR 3001102 Rage 8 DR Works with STM Rage 3 and 4 arm primary clutches for models listed 

ATV Movable Sheave Gen 2 includes bushing, bushing retainer, 1st stage roller pins and set screw installed. 

The Newest addition to our Rage3 line of primary clutches This Rage 3RA is an STM primary designed with "Short Post" offset allowing it to ONLY be used with the STM Short Post Seconday clutches . To take full advantage of an optimal...