2021

This fastener kit comes with the following hardware: PER ARM                                                     ...

This cover is designed for and only works with the STM Can-Am Rage 3P primary. 

For STM Polaris RZR XP1K Special Primary option only

Tied clutch brace primary post bearing retaining snap ring. 

ONLY WORKS IN STM CLUTCHES  Sold in a per arm set. 1 pin and bushing set per arm is needed. Includes: 2 -  1001318 inner bushings for .470 wide weights .098 shoulder bushing 2 -  1001316 outer bushings for .125...

Replacement sheave for Can-Am X3 STM Pneumatic Rage 4 HD clutch

Compression tool for pneumatic primary lock-up clutches includes rod, nut and nylon cup

STM clutch support brace designed to tie the pneumatic primary and secondary together to prevent shaft flexing for improved performance and belt life.  WORKS WITH STM PRIMARY AND SECONDARY ONLY     

Our billet cover is a rigid design made from 6061 aircraft aluminum. This design captures the towers of the movable sheave and helps stop them from spreading.  Our billet cover also allows the use of the Ski-Doo TRA springs which offers a...

3/8"-16 x 3" Bracket to bearing carrier bolt for tied clutches (1001492, 1001493, 1001495, 1001496, 3001133, 4001136). 2 are needed. SOLD INDIVIDUALLY.  

New improved two-way bearing design. The main shaft bearing is now smaller with a 47mm outside diameter allowing a lower initial takeoff ratio than our past design. Allows tighter belt deflection and smoother transmission shifting. An affordable...