2023

Replaces part #2001226

Can only be used with STM Can-Am Rage 6 & 8 primaries with part# 1001000.

Spanner tool for the STM Pneumatic Primary clutch cover stop

ONLY WORKS IN STM CLUTCHES  Sold in a per arm set. 1 pin and bushing set per arm is needed. Includes: 2 -  1001317 inner bushings for .570 wide weights .048 shoulder bushing 2 -  1001316 outer bushings for .125...

Replacement sheave for the STM Can-Am X3 secondary. Comes with bushing and bushing retaining clip installed  Updated part from original part# 3001049

Bearing Block Bearing for the STM Pneumatic Primary Lock Up clutch   

A heavy duty tool (also known as the grunt tool) that allows you to remove and install your spider. It will work on the STM primary clutch cover as well to hold it from turning while torquing the clutch bolt. This tool works on all STM Rage 4 &...

ONLY WORKS IN STM CLUTCHES  Sold in a per arm set. 1 pin and bushing set per arm is needed. Includes: 2 -  1001317 inner bushings for .570 wide weights .048 shoulder bushing 2 -  1001316 outer bushings for .125...

Cylinder for the STM Pneumatic Primary Lock Up clutch   

ATV Primary Fixed Sheave Gen 2 contains fixed sheave part# 3001010 and post part# 3001007 assembled. Fits Rage 3, 6 and 8. Works with Rage 3P short post offset (not standard Rage 3P with stock offset) Does not work for standard Rage3S or Rage3P...

Shim for Rage Primary Quick Adjust - .060. Four are needed.  Sold individually.

Tied clutch brace primary post bearing.