35MM

ONLY WORKS IN STM CLUTCHES  **Updated part # from 28ACS312** Sold in a per arm set. 1 pin and bushing set per arm is needed. Works with fixed style cam arms that have set screws to fix the arm to the pins-only for .470 wide cam arms...

A heavy duty tool (also known as the grunt tool) that allows you to remove and install your spider. It will work on the primary clutch cover as well to hold it from turning while torqueing the clutch bolt. This tool works on all STM Rage 3 & 6...

ONLY WORKS IN STM CLUTCHES  **Updated part # from 27ACS312** Sold in a per arm set. 1 pin and bushing set per arm is needed. Works with fixed style cam arms that have set screws to fix the arm to the pins-only for .570 wide cam arms...

ONLY WORKS IN STM CLUTCHES  **Updated part # from 26RYCA** Sold each set. 1 pin and bushing set per arm is needed. Works with fixed style cam arms that have set screws to fix the arm to the pins. Only for .570 wide cam arms with 8mm bushings...

Bushing and retaining clip.

TRA spring spacer for the STM Rage primary clutch. These spacers go in each end of the TRA spring to protect the cover and spider from spring damage.

This compression tool will allow you to change weights in your clutch without removing it from the crank. Simply remove the belt and clutch bolt, screw in the m14 x 1.5 thread rod with the plastic cup and tighten the nut to collapse the sheaves.

Spider retaining nut STM Rage Primary Clutches 

Bushing Retaining Clip.

Screw-on spider shim .06 thick. Fits 30 and 35mm taper.

Screw-on spider shim .03 thick. Fits 30 and 35mm taper.

Snowmobile Primary Fixed Sheave and Post assembled