-STM Rage Primary Clutch Replacement Components
-
Can-Am X3 Pneumatic Primary Clutch Retaining Bolt M14-1.5 x 109mm
$63.00Primary clutch retaining bolt for the Can-Am X3 Pneumatic Lockup clutch only. M14 - 1.5 x 109mm 1/2" thin walled socket required for installation Torque to 80 ft/lbs$63.00 -
4 Arm Non-Fixed SuperTip Tuning Fastener Kit
$69.00NON-FIXED PIN Fastener kit comes with the following hardware: This kit is for Cam Arm that utilize bushings to pivot on the pin kits Fastener kit comes with the following hardware:Supplied per arm: 2 - 7 gram tungsten...$69.00 -
Pneumatic Primary Bearing Block Bearing Snap Ring.
$5.00Pneumatic clutch snap ring for bearing. Sold individually.$5.00 -
STM Rage 3WCP Can-Am Primary Wide Captured Pin Movable Sheave w/Turned Angle 8.5"
$542.00Replacement movable sheave for the 3001121 Primary includes bushing & snap ring (Part # 1001004)$542.00 -
Rage 4 Screw-On HD Spider
$516.00Four arm screw-on HD spider complete with rollers and buttons. Works in STM Rage 4 HD primary 8-3/4" diameter or larger. Rebuild kit available: #1001651$516.00 -
STM RAGE 4WCP Primary Movable Sheave w/Turned Angle 8.5" Can-Am Defender/X3/Maverick Trail/Maverick Sport
$542.00Replacement movable sheave includes bushing & snap ring (Part # 1001004)$542.00 -
Screw-On HD Spider Shim .03 Thick for 1.875" dia post- Set of 4
$9.00Screw-on HD spider shim .03 thick. Fits STM 30, 33 and 35mm primary clutch with 1.875" dia post Old part number - 25-30-35-HD-SO-03$9.00 -
Currently Out of Stock, Please check back again
Gram Scale.
$25.00Pocket gram scale. Maximum 200 gram capacity. Perfect tool for setting up your cam arms. Comes with batteries, protective cover, storage case and is calibrated. Gram scale is 4.6 x 2.5 x 0.7 inch and weight under 4 ounces Weight platform...$25.00 -
STM Rage 4 Wide Arm Spread Pin ATV Spider (No spring boss)
$422.00Rage 4 Wide spider without spring boss Made from Forged aluminum. Comes assembled with rollers and buttons kit part# 1001591 Replaces 1001556$422.00 -
STM Short Boss Rage 4 Snowmobile Primary Cover
$204.00Our billet cover is a rigid design made from 6061 aircraft aluminum. This design captures the towers of the movable sheave and helps stop them from spreading. Our billet cover also allows the use of the Ski-Doo TRA springs which offers a...$204.00 -
Pneumatic Clutch Cover Holding Tool
$84.00This tool fits all pneumatic clutch styles. Press pieces married in holes for your application only. Used to hold the clutch for torquing the main bolts and actuator parts.$84.00 -
Pneumatic Primary Compression Tool 30, 33 & 35MM
$37.00Compression tool for pneumatic primary lock-up clutches includes rod, nut and nylon cup$37.00