Rage 6 Replacement Components

TRA spring spacer for the STM Rage primary clutch. These spacers go in each end of the TRA spring to protect the cover and spider from spring damage.

2610 bushing and VH181 Snap Ring 

Spider retaining nut STM Rage Primary Clutches 

Bushing Retaining Clip.

30mm screw-on belt shim .03 thick.  Sold individually.

Replacements for spiders that came with these HD arms. Arms are sold individually and come with bushing already installed. HD 1st stage M5 fastener kit required with these arms and is sold separately.  These Cam Arms are not recommended at...

Screw-on spider shim .06 thick. Fits 30 and 35mm taper.

Screw-on spider shim .03 thick. Fits 30 and 35mm taper.

Set of 3 rollers.

Includes: 1 pin 1/4"x 1.5"  2 set screws 5/16"x3/8"

This compression tool will allow you to change weights in your clutch without removing it from the crank. Simply remove the belt and clutch bolt, screw in the thread rod with the plastic cup and tighten the nut to collapse the sheaves.  5/8-18...

Cover screw set for the STM snowmobile dual stage Rage 6 primary clutches. Torque to 125 in/lbs. Comes with 6 bolts as shown.